Contact Us
Tel：
E-mail：
Address:
PFN Germany GmbH Hammer Landstrasse 117 41460 Neuss Germany
Aluminum cut wire shot
- Product description
- Technique index
- Application areas
- Sizes
- Packaging
-
Aluminum cut wire shot
In producing our aluminium cut wire to be inert, we already meet the increasing demands of the aluminium casting and forging industries. Further advantages of this homogenous cut wire are the protection of the blasting equipment, economic efficiency and compliance with low roughness requirements. Deburring of magnesium castings is also possible with this material.
-
Typical physical properties
· Hardness: approx. HV35-45/HV90-110
· Grain shape: cylindrical/rounded
· Melting point: ca. 630 °C
· Specific gravity: approx. 2,7 g/cm³
· Bulk density*: approx. 1,7 g/cm³
*depending on grain size
Chemical Compostion
EN AW-5056
EN AW-1017
Si
0,30 %
max. 0.16%
Fe
0,10 – 0,40 %
max. 0.16%
Cu
max. 0,10 %
0,01%
Mn
0,10 – 0,60 %
Mg
4,50 – 6,00 %
Cr
max. 0,20 %
Zn
max. 0,30 %
TI
max. 0,30 %
Andere
0,15 %
max. 0.026%
Al
Remainder
99.7%
-
Application areas
Blast cleaning
Deburring
Reusable abrasive
Surface finish
-
Sizes
Cylindrical / Spherical
Diameter(mm)
0.6, 0.8, 1.0, 1.2, 1.6, 2.0, 2.2, 3.0
Other grain sizes can be produced if required.
Blasting System
Pressure blast machines
Wheel blast machines
Injector blast cabinets
-
Packaging
10kg sacks on pallet up to 500kg; 500kg / 1t loose in a big bag
Hot Tags:
Aluminum cut wire shot
PREVIOUS:
NEXT:
Inquire Now
Note: Please leave your email address, our professionals will contact you as soon as possible!
Contact
Tel：
E-mail：
Address:
PFN Germany GmbH Hammer Landstrasse 117 41460 Neuss Germany
Message
Note: Please leave your email address, our professionals will contact you as soon as possible!
Copyright © PFN Germany GmbH